404

[ Avaa Bypassed ]




Upload:

Command:

botdev@3.21.159.60: ~ $
/* SPDX-License-Identifier: GPL-2.0 */
/*
 * Standard pin control state definitions
 */

/**
 * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
 *	into as default, usually this means the pins are up and ready to
 *	be used by the device driver. This state is commonly used by
 *	hogs to configure muxing and pins at boot, and also as a state
 *	to go into when returning from sleep and idle in
 *	.pm_runtime_resume() or ordinary .resume() for example.
 * @PINCTRL_STATE_INIT: normally the pinctrl will be set to "default"
 *	before the driver's probe() function is called.  There are some
 *	drivers where that is not appropriate becausing doing so would
 *	glitch the pins.  In those cases you can add an "init" pinctrl
 *	which is the state of the pins before drive probe.  After probe
 *	if the pins are still in "init" state they'll be moved to
 *	"default".
 * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
 *	when the pins are idle. This is a state where the system is relaxed
 *	but not fully sleeping - some power may be on but clocks gated for
 *	example. Could typically be set from a pm_runtime_suspend() or
 *	pm_runtime_idle() operation.
 * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
 *	when the pins are sleeping. This is a state where the system is in
 *	its lowest sleep state. Could typically be set from an
 *	ordinary .suspend() function.
 */
#define PINCTRL_STATE_DEFAULT "default"
#define PINCTRL_STATE_INIT "init"
#define PINCTRL_STATE_IDLE "idle"
#define PINCTRL_STATE_SLEEP "sleep"

Filemanager

Name Type Size Permission Actions
consumer.h File 4.27 KB 0644
devinfo.h File 1.44 KB 0644
machine.h File 5.01 KB 0644
pinconf-generic.h File 9.28 KB 0644
pinconf.h File 2.66 KB 0644
pinctrl-state.h File 1.54 KB 0644
pinctrl.h File 7.43 KB 0644
pinmux.h File 3.83 KB 0644