#!/bin/sh set -e # Automatically added by dh_systemd_enable/11.1.6ubuntu2 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then # This will only remove masks created by d-s-h on package removal. deb-systemd-helper unmask 'lm-sensors.service' >/dev/null || true # was-enabled defaults to true, so new installations run enable. if deb-systemd-helper --quiet was-enabled 'lm-sensors.service'; then # Enables the unit on first installation, creates new # symlinks on upgrades if the unit file has changed. deb-systemd-helper enable 'lm-sensors.service' >/dev/null || true else # Update the statefile to add new symlinks (if any), which need to be # cleaned up on purge. Also remove old symlinks. deb-systemd-helper update-state 'lm-sensors.service' >/dev/null || true fi fi # End automatically added section # Automatically added by dh_installdeb/11.1.6ubuntu2 dpkg-maintscript-helper rm_conffile /etc/blacklist.d/lm-sensors 1:2.9.0-14~ -- "$@" # End automatically added section # Automatically added by dh_installdeb/11.1.6ubuntu2 dpkg-maintscript-helper rm_conffile /etc/modutils/i2c 1:3.0.1-4~ -- "$@" # End automatically added section # Automatically added by dh_installdeb/11.1.6ubuntu2 dpkg-maintscript-helper rm_conffile /etc/modprobe.d/i2c 1:3.1.0-1~ -- "$@" # End automatically added section # Automatically added by dh_installdeb/11.1.6ubuntu2 dpkg-maintscript-helper mv_conffile /etc/modprobe.d/lm-sensors /etc/modprobe.d/lm-sensors.conf 1:3.1.0-1~ -- "$@" # End automatically added section # Automatically added by dh_installdeb/11.1.6ubuntu2 dpkg-maintscript-helper rm_conffile /etc/init.d/fancontrol 1:3.1.1-5~ -- "$@" # End automatically added section # Automatically added by dh_installinit/11.1.6ubuntu2 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -x "/etc/init.d/lm-sensors" ]; then update-rc.d lm-sensors defaults >/dev/null || exit 1 fi fi # End automatically added section